Contact me for VHDL or Verilog projects and assignments

Wednesday, March 9, 2011

Clock Frequency converter in VHDL

In FPGA designs, there are situations where you want a clock signal with a small frequency(or high time period). But in most of FPGA boards the frequency of the crystal oscillators available are of the range of tens of MHz.

One solution to the above problem is to take the high frequency clock available on board and convert it to a lower frequency clock. This is called frequency down conversion. I have shared a code here for a general purpose clock down converter.

The entity clk_gen takes a high frequency clock, Clk and an integer value divide_value as inputs and produces the converted clock at Clk_mod. The divide_value is defined as follows:

divide_value = (Frequency of Clk) / (Frequency of Clk_mod).

For example if you want to convert a 100 MHz signal into a 2 MHz signal then set the divide_value port as "50".

Without much further explanation I will give you the code:

library IEEE;

entity clk_gen is
port(   Clk : in std_logic;
        Clk_mod : out std_logic;
        divide_value : in integer
end clk_gen;

architecture Behavioral of clk_gen is

signal counter,divide : integer := 0;


divide <= divide_value;

    if( rising_edge(Clk) ) then
        if(counter < divide/2-1) then
            counter <= counter + 1;
            Clk_mod <= '0';
        elsif(counter < divide-1) then
            counter <= counter + 1;
            Clk_mod <= '1';
            Clk_mod <= '0';
            counter <= 0;
        end if;
    end if;
end process;   

end Behavioral;

The testbench code used for testing the code is given below:

  LIBRARY ieee;
  USE ieee.std_logic_1164.ALL;
  USE ieee.numeric_std.ALL;

  ENTITY testbench IS
  END testbench;

  ARCHITECTURE behavior OF testbench IS

    signal clk,clk_mod :  std_logic;
    signal divide_value :  integer;
    constant clk_period : time := 10 ns;

  -- Component Instantiation
          uut: entity work.clk_gen PORT MAP(
                  clk => clk,
                  clk_mod => clk_mod,
                        divide_value => divide_value );

    simulate : process
        divide_value <= 10;  --divide the input clock by 10 to get 10(100/10) MHz signal.
        wait for 500 ns;
        divide_value <= 19;  --divide the input clock by 19 to get 5.3(100/19) MHz signal.
    end process;

    clk_process :process  --generates a 100 MHz clock.
        clk <= '0';
        wait for clk_period/2;  --for 5 ns signal is '0'.
        clk <= '1';
        wait for clk_period/2;  --for next 5 ns signal is '1'.
   end process;


Note :- The code was simulated and synthesised successfully using Xilinx Webpack version 13.1. It should work fine under other tools as well. 
Related Posts with Thumbnails